FEATURES AND CONTROLS
35
Dual Handle Console Control with CAN Trackpad Features and
Operation
1. Operation of shift and throttle is controlled by the movement of the control handle. Push the control
handle forward from neutral to the first detent for forward gear. Continue pushing the handle
forward to increase speed. Pull the control handle back from neutral to the first detent for reverse
gear. Continue pulling the handle back to increase speed.
F
N
R
3417
2. Trim switch (if equipped) - Pressing the trim switch allows the engine to trim up and down.
3. Neutral lights - The neutral lights illuminate when the engine is in neutral gear position. The lights
will flash when the engine is in throttle only mode.
NOTE: Gear position is determined by the position of the shift actuator on the engine, not the position
of the control handle.
4. Troll button - Pressing the "TROLL" button activates troll control. The troll control feature allows
the boat operator to set the engine speed for slow speed cruising or maneuvering. To activate,
move the control handles into forward detent and press the button. Use the - or + buttons to
decrease or increase speed, up to a maximum of 1000 RPM. If troll control is set at a desired
speed and then shut off, the system remembers the set speed and will return to that speed when
re-engaged. To turn off the troll control press the "TROLL" button, move the throttle to a different
speed, or shift the engine into neutral.
5. Transfer button - Pressing the "TRANSFER" button allows engine operation to be transferred
from a different helm. Refer to Helm Transfer.
6. Dock button - Pressing the "DOCK" button initiates docking mode. Docking mode reduces throttle
capacity to approximately 50% of normal throttle. To turn off docking mode, shift the engine into
neutral and press the "DOCK" button.
7. Throttle only button - Allows the boat operator to increase engine RPM for warm-up, without
shifting the engine into gear. To engage throttle only, move the control handle into the neutral
position. Press the throttle only button and move the control handle ahead to the forward detent.
The horn will sound once and the neutral light will start flashing. The horn will sound twice when
throttle only is engaged. Advance throttle to increase engine RPM. To disengage, return control
handle to neutral position and press the throttle only button. Engine RPM is limited to prevent
engine damage.
To Next Page
Loading...
