Mercury 300 Verado - Storage Preparation

MAINTENANCE
73
Checking Power Trim Fluid
1. Tilt outboard to the full up position.
2. Rotate the tilt support bracket down.
3. Lower outboard until tilt support bracket rests on pedestal.
4. Remove the power trim fill cap. The fill cap only requires 1/4 turn to remove.
a
c
d
b
29312
a - Tilt support lever
b - Power trim fill cap
c - Tilt support bracket
d - Pedestal
5. The fluid level should be approximately 25 mm (1 in.) from the top of the fill neck. Add Quicksilver
or Mercury Precision Lubricants Power Trim & Steering Fluid. If not available, use automotive
automatic transmission fluid (ATF).
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering
Fluid
Power trim system 92-802880Q1
6. Reinstall the power trim fill cap. Tighten fill cap 1/4 turn. Cap will snap in place. Do not tighten
beyond this point.