FEATURES AND CONTROLS
38
Synchronizing Helms Prior To Transfer
Pressing the "TRANSFER" button allows the boat operator 10 seconds to match up the control handle
settings at the new helm with the handle settings that are at the old (to be inactive) helm. If the handles
are not matched, the neutral lights will flash. The light blinks faster as the handles are nearing match
position. Once the light stays on continuously, the handles are matched and the button can be pressed
again to complete the transfer. This completes the transfer process, and gives control to the new station.
If the helm transfer is not completed within 10 seconds, the action will be cancelled.
Shadow Mode Control Features and Operation
TRIPLE ENGINE THROTTLE AND SHIFT OPERATION
Movement of the handles on the remote control allows the boat operator to control the engine throttle
speed and gear shift positions of all three engines.
The throttle and shift function is dependant on what engines are running. Refer to the following table.
Port Engine Center Engine Starboard Engine Control Handle Function
Running Running Running
Port engine throttle and shift
= controlled by port control
handle
Starboard engine throttle
and shift = controlled by
starboard control handle
Center engine throttle =
average of port and
starboard engines
Center engine shift = neutral
unless both engines are in
the same gear
Running Running Off
Port and center engine
throttle and shift = controlled
by port control handle
Off Running Running
Starboard and center
engine throttle and shift =
controlled by starboard
control handle
Running Off Running
Port engine throttle and shift
= controlled by port control
handle
Starboard engine throttle
and shift = controlled by
starboard control handle
Running Off Off
Port engine throttle and shift
= controlled by port control
handle
Off Off Running
Starboard engine throttle
and shift = controlled by
starboard control handle
Off (ignition key switch
turned on)
Running
Off (ignition key switch
turned on)
Center engine throttle and
shift = neutral/idle unless
both control handles are in
the same gear
To Next Page
Loading...
