FEATURES AND CONTROLS
44
Port Engine Center Engine Starboard Engine Control Handle Function
Off Running Running
Starboard and center
engine throttle and shift =
controlled by starboard
control handle
Running Off Running
Port engine throttle and shift
= controlled by port control
handle
Starboard engine throttle
and shift = controlled by
starboard control handle
Running Off Off
Port engine throttle and shift
= controlled by port control
handle
Off Off Running
Starboard engine throttle
and shift = controlled by
starboard control handle
Off (ignition key switch
turned on)
Running
Off (ignition key switch
turned on)
Center engine throttle and
shift = neutral/idle unless
both control handles are in
the same gear
Turning off one of the outer engines while underway will cause the center engine to go into forced neutral/
idle. Operation to the center engine can be restored by moving the control handle of the functioning outer
engine back into neutral position and then re-engaging. The center engine speed and gear shift will then
be controlled by the functioning outer engine.
Turning off the center engine while underway will have no effect on the operation of the outer engines.
If a failure should occur while underway which causes one of the outer engines into forced neutral/idle
condition, the center engine will also be forced to neutral/idle. Operation to the center engine can be
restored by moving the control handle of the functioning outer engine back into neutral and then re-
engaging.
QUAD ENGINE THROTTLE AND SHIFT OPERATION
Movement of the handles on the remote control allows the boat operator to control the engine throttle
speed and gear shift positions of all four engines.
The throttle and shift function is dependant on what engines are running. Refer to the following table.
Port Outer Engine Port Inner Engine
Starboard Inner
Engine
Starboard Outer
Engine
Control Handle
Function
Running Running Running Running
Port inner and outer
engines throttle and
shift = controlled by
port control handle
Starboard inner
and outer engines
throttle and shift =
controlled by
starboard control
handle
Running Running Off Off
Port inner and outer
engine throttle and
shift = controlled by
port control handle
To Next Page
Loading...
