35
OPERATION
2
4
1
3
Starting The Engine
Before starting, read the Pre-Starting Check List, Special Operating
Instructions, and Engine Break-in Procedure on the first three pages
in the Operation Section.
CAUTION
!
Prevent damage to the water pump (running dry) or overheat-
ing of the engine. Never start or run your outboard (even mo-
mentarily) without water circulating through all the cooling
water intake holes in the gear case.
1 Lower the outboard to the run position. Make sure all the cooling
water intake holes are submerged.
2 Open fuel tank vent screw (in filler cap) on manual venting type
fuel tanks.
3 Squeeze the fuel line primer bulb several times until it feels firm.
4 Set the lanyard stop switch to RUN position. Read the Lanyard
Stop Switch safety explanation and Warning in the General In-
formation Section.
To Next Page
Loading...
