52
MAINTENANCE
12
a
b
c
Checking Power Trim Fluid
1
Place outboard in the full down (in) position.
2 Remove fill/vent screw (a). Wipe with a clean, lint-free cloth and
reinstall - DO NOT THREAD INTO PUMP. Remove fill/vent screw
and note oil level. Oil level must be between the “ADD” (c) and
“FULL” (b) marks on dipstick. If necessary, add Quicksilver Pow-
er Trim & Steering Fluid or SAE 10W-30 or 10W-40 motor oil thru
the fill/vent screw hole to bring level up to the “FULL” mark on the
dipstick. DO NOT OVERFILL.
3 To purge system of air, raise the outboard 2 or 3 times. Recheck
oil level and add oil if necessary.
4 Reinstall fill/vent screw by turning it all-the-way in, then back it out
one and a half (1-1/2) turns.
CAUTION
!
Fill/Vent screw MUST BE backed out one and a half (1-1/2)
turns (after bottoming out) to vent pump reservoir.
FAILURE
TO BACK SCREW OUT COULD RESULT IN DAMAGE TO
PUMP.
To Next Page
Loading...
