20
* Pass thread from back to the front through the
thread guide 1.
* Thread the top cover thread guide by pulling the
thread towards the right until it slips under guide.
Then pull thread along the right side of button as
illustrated.
1
2
2
3
3
4
5
6
7
8
9
10
5
* Continue to thread points 4~9.
* Slip the thread into the front slot on the thread
guide (5) and into the slot on the take-up lever
cover (6). Then slip the thread into the left slot on
the thread guides (7) and (8).
* Before threading the eye of the needle, make sure
thread is in front of thread guide located on the
bottom of the needle clamp (9).
* Thread the eye of the left needle. Use the needle
threader (page 21) to make the threading easier.
* Pull about 10 cm (4") of thread through needle
eye to hang free.
* Place the thread to the back, under the presser
foot.
* While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
To Next Page
Loading...
Need help?
General
