2
4
3
15
* While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
* Turn the hand wheel toward you until the lower
looper extends out 5~10mm from the throat plate
edge.
* Thread the looper area of the machine following
the red color coded thread guides 3~8.
Note: Use tweezers provided in the accessory
case to aid in threading the looper.
* Place the thread with the point of the tweezers
slightly from left and to the right of threading guide 3.
* Thread the looper eye (A) from front to back.
Pull about 10cm (4 inches) of thread.
Position thread into V cutout (B) on threader.
Firmly hold thread tail with left hand and pull
Threader lever (C) up into place (D).
3
3
4
4
5
6
7
7
8
9
5
6
7
8
9
To Next Page
Loading...
