19
* To change thread type or color, clip thread near
the spool.
* Place new thread on stand.
* Tie new thread and old thread ends together with a
square knot. Clip thread tails to 2~3cm (1 inch)
length. If clipped too short, threads may come
untied.
* Firmly pull both thread to test knot security.
* Raise Presser foot to release Tension discs.
* Pull the threads through the machine one at a time.
* If threads do not pull easily, check for tangles on
thread guides or looping under thread stand.
* When pulling thread through the needles, STOP
when the knot is in front of the needle.
* Cut the thread, and insert it through the needle.
14 TITCH LENGTH. S
* The stitch length can be adjusted
from 1 to 4 mm.
Higher number longer stitch lower*=,
number = shorter stitch.
* Basic stitch length N=.
13. HOW TO CHANGE THREADS:
TIE ON METHOD
To Next Page
Loading...
