Merrylock MK740DSA User Manual

2
4
3
18
* Thread the top cover threadguide by pulling the
thread towards the left until it slips under guide.
Then pull thread along the right side of button as
illustrated.
* While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
* Continue to thread points 4~9.
Note: Slip thread into the middle slot of the thread
guide 5 and into the lower slot of take-up lever
cover 6.
Then continue by slipping thread into the middle
slot of the thread guides 7 and 8.
Note: For 4 thread overlock left needle: Use neddle A.
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
Before threading eye of needle, make sure thread
is located on the bottom ofin front of thread guide
the needle clamp.
* Thread the eye of the left needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
* The position of the thread must be behind the the
thread guide.
* Draw about 10cm (4 inches) of thread through
needle eye to hang free.
* Place the thread to the back, under the presser foot.
2
2
3
3
4
5
6
7
8
9
9

Merrylock MK740DSA Specifications

General

Brand	Merrylock
Model	MK740DSA
Category	Sewing Machine
Language	English