17
* Continue to thread points 4~9.
Note: Slip thread into the rear slot on the thread guide 5 and
bottom slot of take-up lever cover 6. Then slip thread
into the right slot on the thread guide 7.
* Before threading eye of needle, slip thread behind thread
guide located on the bottom of the needle clamp.
*
Thread the eye of the right needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
* The position of the thread must be behind the thread
guide.
* Draw about 10cm(4 inches) of thread through
needle eye towards the rear of machine.
* Place the thread to the back, under the presser
foot.
(4) Threading the threading the left needle
(Yellow) (A on needle clamp)
* Thread the left needle as indicated 1~9.
* Raise Presser foot to release Tension discs.
* Pass thread from back to the front through the
thread guide 1.
3
1
2
4
4
5
5
6
6
7
7
8
9
8
9
9
1
To Next Page
Loading...
