Merrylock MK740DSA - ( 2) Threading the Lower Looper (Red)

10cm
(4")
14
* Thread the looper area of the machine following the
green color coded thread guides (4~7).
Thread the hole in the upper looper from front to*
back 7. Note: Make sure thread passes behind
lower looper.
Note: Use tweezers provided in the accessory
case to aid in threading the looper.
* Pull about 10cm(4 inches) of thread through the
looper and place to the back of the throat plate.
(2) Threading the (Red)lower looper
* Thread the lower looper as indicated 1~9.
* Raise Presser foot to release Tension discs.
* Pass thread from back to the front through the
thread guide 1.
* Thread the top cover thread guide by pulling
the thread towards the left until it slips under
guide. Then pull thread along the right side of
button as illustrated.
1
2
2
7
6
5
4
1
2
3
4
5
6
7
8
9