3.2. Main Components of M=Light LED
I LED array with status indication
I Aluminum housing
I Support bracket for one- and two-point attachment
I CAN-bus connections
I M=Light control software for control of the M=Light LED via CAN-bus
I CAN-bus interface for control of the CAN-bus via PC-USB connection (optional).
3.3. Special Properties and Performance Data
I No warm-up time required - ready for operation directly after switch-on.
I Test object is NOT overheated by radiation of heat.
I Can be synchronized with camera shutter.
I CAN-bus-controlled
I Non-flickering and dimmable
I Stable aluminum housing
I Customized lighting angles
I Service life of the LEDs more than 50,000 hours
I Delay between trigger input and light flash approx 10 µs
To Next Page
Loading...