To Next PageTo Next Page
Need help?Do you have a question about the MESSRING M-LIGHT LED and is the answer not in the manual?
General| Beam Angle | 120° |
|---|---|
| Material | Aluminum |
| Frequency | 50/60 Hz |
| Power | 100 W |
| Color Temperature | 3000K, 4000K, 5000K |
| Power Consumption | 100W |
| Operating Voltage | AC 100-240V |
| Voltage | AC 100-240V |
| Lifespan | 50000 hours |
Information on hazards, safety instructions, and intended use.
Identifies primary hazards associated with the M=Light LED.
Details risks of electric shock and electromagnetic interference.
Addresses risks from falling units and power cable issues.
Warns about eye damage from light and burns from hot surfaces.
Explains synchronization of pulsed operation with high-speed cameras.
Details the rear panel connections and control elements.
Covers system requirements and the installation process for the software.
Lists necessary hardware and OS requirements for software installation.
Step-by-step guide for installing the M=Light Control software.
Explains how to set permanent switch-on or switch-off.
Describes controlling light via input signals (Flash H/L).
Details requirements for sync signal from camera for auto-follow.
Provides reference values for switch-on duration based on intensity.
Steps to avoid errors related to sync signal and parameters.
Guide on how to enable and configure Auto-Follow mode.
Instructions for enabling and configuring Trigger-Follow mode.
Explains trigger input options like rising/falling edge.
Steps for performing a firmware update on M=Light LEDs.
Steps for performing an FPGA update on M=Light LEDs.
Specifies the required intervals for maintaining the M=Light LED.
Details visual and functional checks before executing a test series.
Emphasizes safety measures like disconnecting power and avoiding liquids.
Guide for parameterizing LEDs using CAN-bus connection.
Describes controlling LED switch-on using Flash H and Flash L signals.
Adjusting settings for manual mode using the software interface.
Manual parameterization using address switches without CAN-bus.
