Switch-on and off of M=Light LED via Trigger Line
Open the Steady Light window.
Adjust the required intensity by the Power [%] slide control.
Press Via Sync.
M=Light LED is switched on for permanent operation when the level at the input (Flash H /
Flash L) is changed from recessive to dominant. If the level falls from dominant to recessive,
the M=Light LED is switched off.
Permanent Switch-off of M=LIGHT LED Pro
Open the Steady Light window.
Press Off.
M=Light LED is permanently switched off and can only be switched on again upon change of
parameterization.
To Next Page
Loading...