5.3.5. Parameterization of M=Light LED for Pulsed Operation
Figure 15: Flash light window
Selects the input signal for the trigger (Figure 17, page 33).
Number of periods per trigger event. In the Software (Mastermode) operating mode an
unlimited number of pulses is emitted if the value is set to 0.
Duration of a period (pulse + pause) in µs. If you set the value for Pulse periode to 0,
the Auto-Follow operating mode is switched on.
Duration of a pulse in µs (switch-on duration).
Time delay by which the pulse is to be retarded in comparison with the trigger input
time. If for Pulse delay the parameterized value is 0, the delay between trigger event
and light flash is approx. 10µs.
Intensity with which M=Light LED is to be switched on as long as the pulse is active.
In pulsed operation, the intensity may be increased up to 255%.
Transmit set parameters to M=Light LED.
Switches all connected M=Light LEDs to power = 0%
Theoretically possible pulse sequence at the trigger input for selected parameters.
To Next Page
Loading...