MESSRING M-LIGHT LED - Special Accessories

Special Accessory - Protective Cover
Special Accessories
58
/
58
20.03.2015
8LE-D23_BA_E
9.1.2. Structure of the Protective Cover
Item:
Description
1
Attachment screws for PMMA
cover
2
PMMA cover
3
Support bracket for protective
cover
4
Attachment screws for support
bracket
5
M=Light-LED housing
Figure 33: M=Light-LED
9.1.3. Retrofitting the Protective Cover to M=Light LED
 Disconnect the M=Light LED from voltage supply
 Remove the front attachment screws from the housing (2 x 2 screws).
 Mount the support bracket by inserting two screws in the positions of the front attachment
screws.
 Fasten the PMMA cover to the support brackets with 3 screws per bracket.
Now the protective cover is mounted on the M=Light-LED. You can take the M=Light-LED back
into operation.