MESSRING M-LIGHT LED - 5.3.7. Firmware and FPGA Updates; Firmware Update Procedure

Operating the Software
Software
40
/
58
20.03.2015
8LE-D23_BA_E
5.3.7. Performing a Firmware or FPGA Update.
Figure 29: Update window
NOTICE!
Failure of the M=Light LED due to incomplete firmware or FPGA update
If the update of an M=Light LED is aborted, this may result in failure of the
M=Light LED.
 The firmware or FPGA update must always be completed.
 Any M=Light LEDs failed due to an incomplete update must be sent to
MESSRING for repair.
Performing a Firmware Update
 Highlight an M=Light LED using the left mouse button.
 Press in section Firmware Update.
 The browser window for selection of the update file is opened.
 Only use update files that have been approved by MESSRING for your M=Light LED.
 Press Update.
 Wait for the update to be completed, DO NOT abort the process.
 The software update has been performed.