d. Commissioning
Once the MS2601E transmitter has been installed, tested, and properly configured for the probe
in use, it can then be closed and put into service. First, perform one last visual inspection to
ensure that all electrical connections are secure and that the enclosure o-ring is in place and is in
good condition. Then thread the enclosure lid onto the base fully. Once the lid has been
threaded into place, tighten the Lock Screw to prevent unauthorized tampering.
Figure 10. Enclosure
Lock
Screw
CAUTION: The Lock Screw on the instrument base must be tightened securely to prevent
unauthorized personnel from opening the MS2601E transmitter, and ensure that the Flameproof
safety is not violated. Only qualified personnel should be allowed to install, operate, and
maintenance the MS2601E transmitter.
To Next Page
Loading...