To Next PageTo Next Page
Need help?Do you have a question about the Metra Electronics 99-7878B and is the answer not in the manual?
General| Brand | Metra Electronics |
|---|---|
| Model | 99-7878B |
| Category | Automobile Accessories |
| Language | English |
Disconnect the negative battery terminal and remove the pocket/accessory socket panel below the factory radio.
Remove 8 MM bolt and use a blunt tool to unclip and remove the factory radio chassis.
Remove screws securing the hazard switch and air bag light to the factory radio panel, then detach retaining clips.
Secure the hazard switch and air bag light into the radio housing panel using factory hardware and attach retaining clips.
Slide the DIN cage into the radio housing, secure it, and snap the pocket into the bottom opening.
Slide the aftermarket head unit into the cage and secure it, then reassemble the dash in reverse order.
Mount the ISO brackets to the head unit and snap the pocket into the bottom opening of the radio housing.
Slide the head unit into the radio opening, engage side clips, snap the trim plate, and reassemble the dash.
Cut and remove the center bar from the radio housing and snap double DIN brackets onto the trim plate.
Slide the head unit into the assembly, secure it, snap the double DIN trim plate, and reassemble the dash.
