Metra Electronics 99-7878B - Kit Preparation; Install Switches and Retaining Clips

3
99-7878B KIT PREPARATION
KIT PREPARATION
1
Secure the hazard switch into the radio housing panel using the factory hardware.
( Figure A)
2
Secure the air bag light into the radio housing panel using the factory hardware.
( Figure A)
3
Attach the (8) retaining clips to the radio housing panel in the same location as
removed from the factory radio panel. ( Figure A)
Continue to kit assembly.
HAZARD
SWITCH
TWO
SCREWS
AIR BAG
SWITCH
TWO
SCREWS
8 RETAINING CLIPS
A