To Next PageTo Next Page
Need help?Do you have a question about the Metra Electronics 99-7875 and is the answer not in the manual?
General| Brand | Metra Electronics |
|---|---|
| Model | 99-7875 |
| Category | Automobile Accessories |
| Language | English |
Disconnect the negative battery terminal and remove trim panels from above glove box and left of radio.
Unclip and remove the top of the center console and the pocket assembly.
Remove screws securing the radio, then unclip and remove the radio, climate controls, and A/C vents.
Unclip the hazard switch/air bag light assembly and remove the bottom trim panel.
Remove clips from the back of the factory radio assembly for later use.
Snap hazard switch/air bag light assembly into housing and secure A/C vents with factory hardware.
Secure climate controls and trim panel onto the radio housing using factory hardware.
Attach the retaining clips to the back of the radio housing.
Install DIN cage, aftermarket radio, and pocket into the radio housing.
Mount ISO brackets, slide radio into housing, attach trim plate and pocket.
Prepare housing, attach brackets, install units, and snap on trim plate.
Make wiring connections using EIA color code, tape unused wires, and reassemble.
