METRA - The World’s best kits
®
metraonline.com
REV. 11/14/2017 INST99-7803G
Installation instructions for part 99-7803G
®
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
U.S. PATENT # D756,348
• ISO DIN radio provision with pocket
• ISO DDIN radio provision
• Retains all climate control systems including dual-zone
• Painted gray to match the factory finish
• A) Radio housing trim panel • B) Radio brackets • C) Pocket • D) Panel clip legs • E) (2) Panel clips
• F) (2) Speed clips • G) (2) #10 x ¾” Phillips screws • H) (4) #4 x 3/8” Phillips pan-head screws
• I) (8) #8 x 3/8”
Phillips truss-head screws • Wiring harness (not shown)
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • Included with kit
Antenna Adapter: • Not Required
• Panel removal tool • Phillips screwdriver
TOOLS REQUIRED
Honda Accord 2003-2007
99-7803G
A
B C D E
F G H I
Dash Disassembly ................................................. 2
Kit Preparation ....................................................... 3
Kit Assembly
– ISO DIN radio provision with pocket ...................... 4
– ISO DDIN radio provision ...................................... 5
Axxess Interface Installation ................................ 6
Table of Contents
Note: The door on the factory pocket below the
radio will not function properly with the 99-7803G
installed. As an alternate solution, Metra offers the
88-00-7803 replacement pocket (sold separately).
To Next Page
Need help?
General
