IX 3131 II - 13
3.3.4. Resistance measurement
• Press « POWER » key to turn on the power.
• Press the function key to select Resistance test range.
• Connect the test clip to the component lead.
•
Press frequency key to select 1 kHz or 120 Hz testing frequency.
• Read the display readings for resistance value.
figure 8
3.4. Functional description
3.4.1. Data Hold
This Data Hold function allows the operator to freeze the display. To enter this
mode, press the « DH » pushbutton ; press again to release.
3.4.2. Static Recording
Press the "DH/MAX/MIN/AVG" pushbutton for one second to enter the static recording
mode. The maximum and minimum readings are then stored in memory, while a beeping
tone is produced when a new tested value has been recorded. Push the same button to
cycle through the maximum, minimum and average of the present readings. The MAX,
MIN or AVG indicators will display on LCD will turn on to indicate what value is being
displayed. Whenever the "MAX AVG MIN" indicators appear on the LCD simultaneously,
the display reading is always a present value.
To exit this mode, press and hold the pushbutton for one second.
"
Notes : Static recording captures only stable values and updates the
memory ; it will not record any "OL" (overload) value for any of the
L/C/R functions. In addition, the meter will not record values which are
below 50 counts in Capacitance measurement.
Static recording is only available in manual ranging. The requirement
of static recording will activate the meter into manual ranging after
To Next Page
Loading...
Need help?
General
