Functional description
100.000-count Graphical Multimeters 11
Functional description (cont'd)
•
Selection of Energy Type menu using the keys
.
•
Modification of the Energy Type (battery or acc.) using the
key.
•
Validation and exit from the successive menus using the key.
Recharging of
accumulators,
only on :
MTX 3282
MTX 3283
The 3 accumulators do not need to be removed from the multimeter for
recharging. Recharging is only possible if "Accumulator" has been selected in
the Energy Type menu (see above).
Before carrying out this operation, select the capacity of the accumulators
(2200 mAh by default) fitted in the instrument:
•
Selection: Accumulator in the using the keys
.
•
Validation: Accumulator using the key, opens a menu for setting the
accumulator capacity (in mAh):
•
Selection of the digit to be modified using the
key.
•
Modification of the value using the key
.
•
Validation of the accumulator capacity and exit from the successive menus
using the key .
•
To maintain the accumulators in good condition, run the accumulators down
to the minimum charge olevel before recharging.
•
Then connect the power pack (12 V
DC
, 3 V
AC
) to the jack connector
(see front panel illustration).
•
Connect the power pack (12 V
DC
, 3 V
AC
) to the mains supply.
•
The symbol opposite on the display allows you to monitor the charge status.
The accumulators are fully charged when the symbol stops flashing.
The MTX 3282 and MTX 3283 multimeters contain Ni-MH accumulators.
These accumulators must be disposed of by a recycling firm or a company
specialized in the treatment of dangerous waste materials.
Never dispose of these accumulators with other solid waste.
For further information, contact your MANUMESURE dealer.
When the multimeter is delivered, the accumulators may be discharged,
requiring a complete recharge.
General
t
IR baud 9600
Config user
Accumulator
Energy type
Acc. capacity
To Next Page
Loading...
Need help?
General
