Functional description
100.000-count Graphical Multimeters 13
Functional description (cont'd)
Initial settings
The general menu configures the parameters of the multimeter according to the
conditions of use and the user’s preferences.
•
Opening of the Configuration menu with the key.
•
Selection of the General menu using the keys and then the key.
Choice of language
Selection of the language for the multimeter's menus.
Two options are available: French (Fr) or English (En, default).
Setting the
date and time
Activation of the
buzzer (Beep)
Validation (default), or not , of audio signal (beep) when:
- a key is pressed,
- there is a voltage of more than 60 V
DC
or 30 V
AC
on the "V" input,
- a stable measurement is acquired in AUTO HOLD mode,
- the power supply voltage (battery) is insufficient.
The audio signal is maintained even when the buzzer is deactivated :
∗
during continuity testing,
∗ when the range is exceeded (voltage or current),
∗ on a 10 A measurement,
∗ if the position of the leads and the function selected are incompatible.
Automatic
shutdown (sleep)
Validation (default), or not, of automatic shutdown (sleep) after 30 min if there
has been no action on the multimeter's front panel during that time.
In SURV, MEM and Communication modes, automatic shutdown is not
validated.
For your safety, automatic shutdown is inhibited when the values measured
(voltage, current) on the inputs exceed the danger thresholds (indicator opposite
displayed).
Display contrast
A long press on
directly opens the menu,
validates the setting.
• Modification of the value (default: 50 %)
using the
key
.
•
Validation of setting using
key.
•
Selection of the variables using the key.
•
Modification of the value using
keys
.
•
Clock validation and start-up when menu is
closed using key.
General
u
Date/Time
Sleep off
Set language
Choix langue
Beep on
General
u
Contrast
IR baud 9600
Back-light auto-off
delay
Comm. IR
t
Back-light 10 s
Date and time
10 : 03 : 45
08 : 03 : 2005
Contrast
To Next Page
Loading...
Need help?
General
