￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Installation
￭￭￭￭￭￭￭￭
35
5 Installation
5.1 Installation by Metrohm
NOTE
Installation of the products
As a basic rule, the installation of the system and of the new products
and modules is handled by trained and instructed specialists from the
Metrohm Company and/or its representative.
5.2 Setting up the product
The product has been developed for operation indoors and may not be
used in explosive environments.
Place the product in a location of the laboratory which is suitable for oper-
ation and free of vibrations and which provides protection against corro-
sive atmosphere and contamination by chemicals.
Observe the dimensions and weights of the individual products and mod-
ules that are part of the complete system. You will find this information in
the "Technical specifications" section.
Protect the product against excessive temperature fluctuations and direct
sunlight.
The power cord and other connecting cables must not be replaced with
impermissible cables.
The power cord, where available, or other cables connecting to control
instruments must be accessible during operation.
To Next Page
Loading...
Need help?
General