￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Operation and control
￭￭￭￭￭￭￭￭
69
Press the key once again:
The stirrer stops.
Alternatively, the stirrer can also be switched on and off in the software
under Manual control.
7.3.2 Setting the stirring rate
The stirring rate can be adjusted in 15 steps.
Setting the stirring rate
Prerequisites
￭ The stirrer is switched on.
Proceed as follows:
1
Increasing the stirring rate in stages
Press the key repeatedly.
Each time the key is pressed, the stirring rate is increased by one
step. The current stirring rate is displayed in the software under
Manual control.
2
Reducing the stirring rate
Press the key repeatedly until the desired stirring rate has been
reached.
Each time the key is pressed, the stirring rate is reduced by one step.
The current stirring rate is displayed in the software under Manual
control.
Alternatively, the stirring rate can also be set in the software under Man-
ual control.
NOTE
The stirring direction can be set only in the software under Manual
control.
To Next Page
Loading...
Need help?
General