Metso ND9000P User Manual

2(19)
Table of Contents
1INTRODUCTION ___________________________________________________4
2DEVICE SETUP ____________________________________________________4
2.1 GSD file installation _________________________________________________ 4
2.2 Cyclic communication configuration____________________________________ 4
2.3 Simatic PDM Driver installation _______________________________________ 6
2.4 Basic set-up steps ____________________________________________________ 6
3PDM USER INTERFACE _____________________________________________6
3.1 Parameter groups ___________________________________________________ 7
3.1.1 Identification __________________________________________________________7
3.1.1.1 Operation Unit_______________________________________________________7
3.1.1.2 Device _____________________________________________________________7
3.1.1.2.1 Positioner ________________________________________________________7
3.1.1.2.2 Actuator _________________________________________________________7
3.1.1.2.3 Valve ___________________________________________________________8
3.1.1.3 Batch Information ____________________________________________________8
3.1.2 Settings_______________________________________________________________8
3.1.2.1 Assembly Related Configuration_________________________________________8
3.1.2.2 Profibus Communication Fail Safe Action _________________________________9
3.1.2.3 Valve Diagnostics ____________________________________________________9
3.1.3 Input ________________________________________________________________10
3.1.3.1 Input value_________________________________________________________10
3.1.3.2 Working Range _____________________________________________________10
3.1.3.3 Travel Time________________________________________________________10
3.1.4 Human Interface_______________________________________________________10
3.1.4.1 Maintenance _______________________________________________________10
3.1.4.2 Simulation _________________________________________________________10
3.1.5 Certificates and Approvals_______________________________________________10
3.2 Device menu _______________________________________________________ 11
3.2.1 Operation ____________________________________________________________11
3.2.1.1 Page AUTO ________________________________________________________11
3.2.1.2 Page Remote Cascade ________________________________________________11
3.2.1.3 Page MAN_________________________________________________________11
3.2.1.4 Page Simulation_____________________________________________________11
3.2.2 Calibration ___________________________________________________________12
3.2.3 Flow characterization ___________________________________________________12
3.2.4 Valve test ____________________________________________________________13
3.2.4.1 Step Test __________________________________________________________13
3.2.4.2 Dynamic Loop Test __________________________________________________14
3.2.4.3 Valve Analysis Test__________________________________________________14
3.2.4.4 Valve Deadband Test ________________________________________________15
3.2.5 Reset________________________________________________________________15
3.2.6 Write Protection _______________________________________________________15
3.3 View menu ________________________________________________________ 15
3.3.1 Display ______________________________________________________________15
3.3.2 Device Status _________________________________________________________16
3.3.3 Valve Diagnostics _____________________________________________________16
3.3.3.1 Trends ____________________________________________________________16
3.3.3.1.1 Time Axis_______________________________________________________16
3.3.3.1.2 Reference Value __________________________________________________17
3.3.3.1.3 Steady State Deviation _____________________________________________17
3.3.3.1.4 Dynamic State Deviation ___________________________________________17
3.3.3.1.5 Stiction _________________________________________________________17
3.3.3.1.6 Stable State Load _________________________________________________17

Metso ND9000P Specifications

General

Brand	Metso
Model	ND9000P
Category	Controller
Language	English