-59-
FIGURE 3-82
Install cylinder assembly carefully being certain it seats
squarely on “O” ring in base. Assemble O-Ring and Washer
as shown.
FIGURE 3-79
Remove ram and cylinder assembly from reservoir then pull
ram out of cylinder. Worn packing cup on piston should be
replaced if cloth backing is visible.
FIGURE 3-80
Remove nuts, baffle and retainer rings from studs and screw
the studs into the base. Clean reassemble Sump Base in
reverse order.
FIGURE 3-81
Clean all paint from ram then slide the cylinder over the ram
piston assembly using a rubber or leather mallet.
REASSEMBLY - ALL MODELS
NOTE: Notch on
the washer to be
on underside.
DISASSEMBLY - ALL MODELS
To Next Page
Loading...
