MFJ-464 Instruction Manual CW Keyer/Reader
7
To see how the setup mode menus system works, consider the following example.
EXAMPLE: To enter the setup mode, press and hold the Mode button for two seconds.
If the display shows that you are in the Farnsworth menu, pressing the Next button would
put you in the Weight menu and pressing the Previous button would put you in the
Overall Speed menu. Adjusting the Set dial control would lower or raise the overall code
speed. Once you have selected the speed you desire, you may leave the setup mode by
pressing the Mode button again; or press Previous or Next button to go to another setup
menu.
Once you have made your choices within the setup mode, they will be saved in non-volatile
memory for your next session.
To Next Page
Loading...
