MFJ-464 Instruction Manual CW Keyer/Reader
40
Appendices
Resetting the Keyer
Each time the keyer is turned off, the microprocessor powers down and saves all memories and
configurations to non-volatile memory ready to be used the next time the unit is turned on again.
If the keyer in not working properly, even on initial power on, try resetting to the factory
defaults.
Factory Defaults
The unit is shipped with the following default settings:
• Main Menu Speed
• Setup Menu Overall Speed
• Quick Menu Keyboard Layout
• Overall Speed 13 WPM
• Farnsworth off
• Weight 50%
• Character Space 3 units
• Word Space 7 units
• Keying Compensation 0 msec
• Keying Delay 0 msec
• PTT Hang Time 1000 msec
• Tone Frequency 701 Hz
• Serial Number 0001
• Leading Zeroes on and send as O (dah-dah-dah)
• Other Zeroes send as 0 (dah-dah-dah-dah-dah)
• Nines send as 9 (dah-dah-dah-dah-dit)
• Iambic Mode A
• Reverse Mode off (dot to tip, dash to ring)
• Paddle Mode automatic
• Monitor Mode on
• Output Mode on
• Queue Mode on
• Pulse Tune Speed 75 WPM
• Pulse Tune Weight 13% duty cycle
• Quick Speeds 13, 15, 18 and 20 WPM
• Keyboard Layout Qwerty keyboard
• Repeat Key off
• Caps Lock on
To reset the keyer to these defaults:
To Next Page
Loading...
