MGL Avionics Stratomaster Ultra L - Fuel; Temperature; Oil Pressure; Ambient Temperature Sender

MGL Avionics Stratomaster Ultra “L” Owner’s manual
Page 49
Distances are displayed by the distance traveled indication and range estimate.
Use the + key to change the setting.
(Note: The Stratomaster Ultra will only give you two of the three options at any time. To
make the third option available press to minus key).
Fuel
Select if you want fuel quantity displayed in liters, imperial gallons or U.S. gallons. This
setting also influences the fuel flow display.
Use the + key to change the setting.
(Note: The Stratomaster Ultra will only give you two of the three options at any time. To
make the third option available press to minus key).
Temperature
Select if you would like temperature displayed in degrees Fahrenheit or Celsius. This setting
influences all temperature displays such as ambient, water or oil, EGT, CHT etc.
Use the + and – keys to change the setting.
Oil Pressure
Select if you would like oil pressure displayed in Bar or PSI.
Use the + and – keys to change the setting.
Ambient temperature sender
Normally you should have the ambient temperature sender that is included with the
instrument installed. This setting switches the sender on (default). The sender is required for
density altitude calculations.
Should you switch this item off, the unit will use an internal temperature sensor to obtain a
less accurate temperature reading. It is much preferable to measure the temperature at the
outside of your aircraft or instrument pod.
Use the + and – keys to change the setting.
Fuel flow sender
Select whether or not you have a fuel flow sender installed. The unit will make certain
adjustments to the main display to accommodate the additional fuel flow related displays if
this item is switched on.
You can use the fuel flow sender to display a calculated fuel level should you not have a fuel
level sender installed.
The fuel flow sender is required to calculate range (if the remaining fuel quantity and true
airspeed (TAS) is known).
Fuel flow and remaining fuel quantity are used for the fuel bingo estimate.
Use the + and – keys to change the setting.