MICRO-EPSILON optoNCDT ILR 102 series - Page 40

Page 40
Operation
optoNCDT ILR 102x/110x/115x
Command Name Data to
ILRxx
Data from ILR11xx Specification
„IH1“ input
hysteresis Q1
„000“.. „254“
respectively
0“..“999“
(INCH)
ACK Hysteresis setting around the switching points Q1 in
[mm] or [INCH * 100]
„IH2“ input
hysteresis Q2
„000“.. „254“
respectively
00“..“999“
(INCH)
ACK Hysteresis setting around the switching points Q2 in
[mm] or [INCH * 100]
„IL1“ input limit
Q1 1
Offset ...
+12000+Off-
set respec-
tively Offset ..
48000+Off-
set
ACK Setting of the first switching point Q1 in [mm] or
[INCH * 100]
„IL2“ input limit
Q2 1
Offset ...
+12000+Off-
set bzw
Offset ..
48000+Off-
set
ACK Setting of the first switching point Q2 in [mm] or
[INCH * 100]
„IL3“ input limit Q
analog 1
Offset ...
+12000+Off-
set bzw
Offset ..
48000+Off-
set
ACK ILR11x0 only:
Setting of the 0 % point of the analog characteristic,
see Chap. 6.2.5