PRESERVE_MEM_RANGE_ERROR_UNKNOWN=An unknown error has occurred while trying to validate the user
entered preserve ranges.
PRESERVE_MEM_RANGE_ERROR_WRONG_DATABASE=Unable to access data object while validating user
entered memory ranges.
PRESERVE_MEM_RANGE_MEM_NOT_SELECTED=You have selected to preserve an area of memory but have
not selected to program that area. Please check the preserved ranges on the debug tool's "Memories to Program"
property page and make sure that any preserved memory is also designated to be programmed.
PRESERVE_MEM_RANGE_OUT_OF_BOUNDS=The selected preserve range, %s, does not fall within the proper
range for the memory area selected. Please check the manual program ranges on the debug tool's "Memories to
Program" property page.
PRESERVE_MEM_RANGE_STRING_MALFORMED=The preserve memory range(s) entered on the, "Memories to
Program" property page (%s) is not formatted properly.
PRESERVE_MEM_RANGE_WONT_BE_PROGRAMMED_AUTO_SELECT=Some or all of the preserve memory
ranges (%s) entered on the, "Memories to Program" property page, do not fall under the indicated program range(s)
(%s) for the memory selected. Please deselect the \u201cAuto select memories and ranges\u201d option on the
\u201cMemories to Program\u201d property page, change to manual mode and adjust your range(s) accordingly.
PRESERVE_MEM_RANGE_WONT_BE_PROGRAMMED=Some or all of the preserve memory ranges (%s)
entered on the, "Memories to Program" property page, do not fall under the indicated program range(s) (%s) for the
memory selected. Please check the preserved ranges on the debug tool's, "Memories to Program" property page.
PROGRAM_CFG_WARNING=WARNING: You have selected to program configuration memory. Programming
invalid values into any of the configuration fields may have unintended consequences. Please make sure that
EVERY configuration field has a valid value. If you are not sure, you can read the configuration values off of device
first and then change only the fields you are concerned with. Would you like to continue programming?
PROGRAM_COMPLETE=Programming/Verify complete
PROGRAM_MEMORY=program memory
PROGRAM=program
PROGRAMMING_DID_NOT_COMPLETE=Programming did not complete.
READ_COMPLETE=Read complete
READ_DID_NOT_COMPLETE=Read did not complete.
RELEASEMCLR_FAILED=Release from reset failed.
REMOVING_SWBPS_COMPLETE=Removing software breakpoints complete
REMOVING_SWBPS=Removing software breakpoints...
RESET_FAILED=Failed to reset the device.
RESETTING=Resetting...
RISKY_CFG_RANGE_REMOVED=The configuration memory will not be included in the program operation
because the, "Exclude configuration memory from programming" option is set. To change this, go to the Memories
to Program property page and uncheck the setting.\nWARNING; Programming configuration values on this device
can cause unintended consequences if all of the configuration values are not properly set. It is advised that you
read the configuration values off of device first and then change only the fields you are concerned with.
RUN_INTERRUPT_THREAD_SYNCH_ERROR=An internal run error has occurred. It is advised that you restart
your debug session. You may continue running but certain run time features may no longer work properly.
RUN_TARGET_FAILED=Unable to run the target device.
RUNNING=Running
SERIAL_NUM=Serial Number:\n
Error Messages
© 2020 Microchip Technology Inc.
User Guide
DS50002751D-page 45
To Next Page
Loading...
