8.2.6 Debug Failure Actions
The MPLAB PICkit 4 In-Circuit Debugger was unable to perform a debugging operation. There are numerous
reasons why this might occur. See 6.2 Top Reasons Why You Can't Debug and 6.3 Other Things to Consider.
8.2.7 Internal Error Actions
Internal errors are not expected and should not happen. They are used for internal Microchip development.
The most likely cause is a corrupted installation (8.2.4 Corrupted Installation Actions).
Another likely cause is exhausted system resources.
1. Try rebooting your system to free up memory.
2. Make sure you have a reasonable amount of free space on your hard drive (and that it is not overly
fragmented).
If the problem persists, contact Microchip Support.
Error Messages
© 2020 Microchip Technology Inc.
User Guide
DS50002751D-page 48
To Next Page
Loading...
Need help?
General
