Microhard Systems IPN4GB - Page 156

© Microhard Systems Inc. 156
5.0 AT Command Line Interface
AT+MTWT
Command Syntax
Enable/Disable the Wireless Traffic Timeout. Unit
will reset if it does not see any traffic from the carrier
for the amount of time defined.
AT+MTWT=<Mode>[,<Interval_s>,<Reboot
Time Limit_s>]
Mode:
0 Disable
1 Enable
Reboot Time Limit:300-60000
Description
Example
Input:
AT+MTWT=1,1,300 <enter>
Response:
OK
AT+MRTF
Command Syntax
Reset the modem to the factory default settings
stored in non-volatile (NV) memory. Unit will reboot
with default settings.
AT+MRTF <action>
Action:
0 pre-set action
1 confirm action
OK
Description
Example
Input:
AT+MRTF=1 <enter>
Response:
OK
AT+MSCMD
Command Syntax
Enable/Disable the Wireless Traffic Timeout. Unit
will reset if it does not see any traffic from the carrier
for the amount of time defined.
AT+MSCMD=<Mode>[,<Filter Mode>[,<Phone
No.1>[,...,<Phone
No.6>]]]
Mode:
0 Disable
1 Enable SMS Command
Filter Mode:
0 Disable
1 Enable Phone Filter
OK
Description
Example
Input:
AT+MSCMD=1,1,403556767,4057890909<enter>
Response:
OK