© Microhard Systems Inc. 62
4.0 Configuration
Image 4-3-3: Carrier > Keepalive
4.3 Carrier
4.3.3 Carrier > Keepalive
The Keep alive tab allows for the configuration of the keep alive features of the IPn4G. The
IPn4G can either do a ICMP or HTTP keep alive by attempting to reach a specified address at a
regular interval. If the IPn4G cannot reach the intended destination, it will reset the unit in an
attempt to obtain a new connection to the carrier.
Enable or Disable the keep alive functions in the IPn4G.
Keep Alive Status
Values (Selection)
Enable / Disable
Select the type of keep alive used. ICMP uses a “ping” to reach
a select destination.
Type
Values (Selection)
ICMP / HTTP
Specify a IP Address or Domain that is used to test the IPn4G
connection. (Use the ‘Test’ button to ensure that a reachable
host is used.)
Host Name
Values (IP or Domain)
8.8.8.8
The Interval value determines the frequency, or how often, the
IPn4G will send out PING messages to the Host.
Interval
Values (seconds)
300
The Count field is the maximum number of PING errors such as “Host
unreachable” the IPn4G will attempt before the unit will reboot itself to
attempt to correct connection issues. If set to zero (0), the unit will
never reboot itself.
Count
Values (number)
10
To Next Page
Loading...
