MC-20
User Manual / Installing Dies and Adapters with Dies
16/37
In this section, the installation of dies and adapters with dies will be covered. The
MC-20 can accommodate 2 sizes and styles for both the top insert and bottom insert.
Regardless of the dies that were purchased, your machine will come with adapters.
Each of the four die stems/posts are unique so figuring out what goes where is simple.
Follow the guide below to determine whether the die belongs in the bottom or top
insert. Some die sets may need one or both adapters.
Installing Dies and Adapters with Dies
Our warehouse will typically ship the MC-20 with the dies already set into the
machine. For the purposes of this manual, the safety Mica has been removed for
clarity. It is not advised to remove the safety Mica when switching between dies.
Installing Dies with Adapters
To Next Page
Loading...