MC-20
User Manual / Setup Process Procedures
7/37
The following procedures will guide you step by step while you prepare the MC-20 for
operation. There are several phases but each can be quickly broken down and
accomplished. You will need a set of Allen keys and a set of pliers or the corresponding
wrench size for the nuts.
Assembling the Table and Mounting the MC-20
The following procedure will guide you through setting up the table and mounting the
MC-20. You will need a set of Allen keys and a set of pliers or the corresponding wrench
size for the nuts.
Remove all the contents of the box and layout and
floor
1. Open the rectangular box that contains the table pieces.
2. Remove all the protective packaging, stretch wrap and tape from the pieces.
3. The box contains the following items:
a. Short bolts (8)
b. Long bolts (4)
c. Metal legs (2)
d. Nuts (12)
e. Table (1)
f. Micron cross bars (2)
To Next Page
Loading...