At the end of the programmed exit delay, Nitewatch beeps three times and the ARMED led locks on. The
control is now armed and all night arming zones will sound a pre-alert for the programmed entry delay before
activation.
To arm the system in ‘instant’ mode, press the ARM key for 2 seconds. Nitewatch beeps and the ARMED led
lights. The control is now armed and will activate instantly if any night arming zone is violated.
The Nitewatch emergency panic key may be activated at any time by using two fingers to press both ends of
the EMERGENCY key simultaneously. The back light intensity of these keys may be adjusted up and down
by pressing the right side of the emergency key to increase the brightness and the left side to decrease
brightness. The Nitewatch ‘Auto Dim’ feature will automatically dim the ‘Unsafe’ and ‘Armed’ lamps 60
seconds after the ARM key is pressed.
Hold Down Commands
To use a ‘hold down’ command the function key (keypad digit) must be pressed and held down until a second
key-beep is heard. Note that hold down commands will ONLY function when the alarm control is fully
disarmed. The following hold-down commands are available:
Setting the Real Time Clock Time
It is advisable but not mandatory to set the system real time clock. Check with your installer if the clock has
been set. The clock MUST be set if the auto-arming feature is used. Clock time is in 24 hour format. To set
the clock proceed as follows: Press and hold down key 6 until a second key-beep is heard then enter a master
user code then # then the time in 24 hour format then #.
Example: Setting the alarm system clock to 2:45 pm.
To Next Page
Loading...
Need help?
General
