Press and hold down key 8 until a second key-beep is heard then enter a master user code then # then the
follow me telephone number(s) then * (star). Use the # key between numbers if more than one number is to
be called. Note that the ‘star’ key ends this sequence.
Example: Programming the alarm system to call 8197654 then 8256631 then 5292048
Selecting this option forces all dialler transmissions to be signalled in the ‘home warble’ format. The alarm
will call each number in turn and transmit a siren warble sound followed by a sequence of beeps and a short
pause after which the entire sequence is repeated. The number of beeps sent correspond to the zone number
that has been activated. If the called party presses the * (Star) key on the telephone keypad during the pause,
the call is terminated and no further calls are made. If the ‘Star’ key is not heard by the dialler within 60
seconds, the call is terminated and Scorpion dials the next programmed number.
Smoke Sensor Reset
Some latching style smoke sensors connected to alarm controls, once activated, must be reset through the
alarm keypad. Check with your installer if this type of sensor is used in your system. To reset a latching style
smoke sensor enter 7 # at the keypad. Reset all smoke alarm activations by entering a valid user code.
To Next Page
Loading...
Need help?
General
