Setting the Auto Arming Time
Scorpion may be programmed to auto arm at a pre-set time each day. To access this feature an auto arming
time must be programmed using the [Hold Down] 7 command. Press and hold down key 7 until a second key-
beep is heard then enter a master user code then # then the time to arm in 24 hour format then #.
Example: Setting the auto arming time to 5:30 pm
If a valid auto arming time has been entered, the keypad will sound three beeps every six seconds for the
installer programmed pre-alert time before auto arming. At the end of the pre-alert time the panel starts
counting down the exit delay and sounds the ‘leave now’ warning beeper, then arms all zones. During the pre-
alert, entering any key at the keypad will abort the auto arming cycle. Once the alarm has started the exit timer
and warning beeper, a valid user code is required to abort the arming cycle.
Entering an invalid auto arm time (eg. 2500) disables this function. This is the factory default setting.
Note: To enable auto arming it is also necessary to program the correct time into Scorpion’s real time clock.
Follow Me Mode
This feature must be enabled by the installer during installation. Scorpion may be programmed by the end user
to call one or more phone numbers and report alarms. The called number(s) may be changed at will by entering
the following sequence at the keypad:
To Next Page
Loading...
Need help?
General
