Chime Mode
Your installer must program zones, which will be active in chime mode. If this feature is programmed, each
time a chime mode sensor is activated while the system is disarmed, and chime mode is turned on, the keypad
beeps for approximately five seconds. In this mode, Scorpion can act as a door or area minder when the alarm
system is disarmed. Chime mode is temporarily disabled each time the alarm system is armed. To turn chime
mode on and off press 7 1 then #. For Scorpion Z8020C, where the system has been partitioned, press 7 1 #
for Area A and 7 2 # for Area B.
24 Hour Zones
If your installer has fitted a smoke detector(s) to your system it will be connected to a 24 hour zone, thus
ensuring that this device is always active. In the event of an activation or detector malfunction your alarm
system will activate. Enter a valid user code at the keypad and all sirens will be silenced. If the activation or
malfunction is repeated, Scorpion will count the number of activations until the ‘shutdown’ count has been
reached and then shut down the zone, thus preventing further activations. The user should immediately contact
their alarm service or installation company and report the fault. The system should NOT be armed as this will
re-set the ‘shutdown’ counter and allow further activations.
Icon LCD Keypad (if supplied)
The LCD keypad gives full visual indication of the status of your alarm. The keypad has five graphic symbols,
an area identifier and up to 8 zone indicators depending on the model installed.
‘Power Lead’ Symbol
The ‘power lead’ symbol is on when mains power is present and flashes, together with the ‘system fault’
symbol, when there has been a mains power failure.
To Next Page
Loading...
Need help?
General
