Micron Scorpion Z6020C User Instructions

‘System Fault’ Symbol
The ‘system fault’ symbol flashes when there has been a system fault condition or system panic activated as
described in the table on page 7.
‘Bell’ Symbol
The ‘bell’ symbol is on when an alarm condition has occurred or a system panic activated.
‘Moon’ Symbol
The ‘moon’ symbol is displayed when the system is night armed
‘Padlock’ Symbol
The ‘padlock’ symbol is unlocked when the system is disarmed and locked when away armed or night armed.
‘Area Identifier’ Symbol
The ‘area identifier’ symbol is the four segment box at the lower right hand side of the LCD display. This
symbol shows the area(s) that is armed or night armed. In non-partitioned systems, Area A only is displayed.
‘Zone Indicators’
The ‘zone indicators’ are shown as numbers 1 through 4, 6 or 8 on the top line of the LCD display. These zone
numbers show zones that are arming, alarmed zones and also identify the system fault conditions described in
the table on page 7.
When the system is arming, the LCD will display all programmed zones, the padlock in locked mode and the
area identifier showing the area(s) that is arming. The keypad will sound the ‘leave now’ warning. If any zone
is not secure, that zone number will flash and the keypad will sound a slower beep. The alarm should be
disarmed, the problem identified and the system re-armed.
14

Micron Scorpion Z6020C Specifications

General

Brand	Micron
Model	Scorpion Z6020C
Category	Network Router
Language	English