Micronta 22-195A - MEASUREMENT RANGES AND DISPLAY NOTES; Function and Range Table; Range Notes and Indicators

DCV/ACV
DCA/ACA
Continuity
+> check
hee check
300 mV (DCV only)
3 V
30 V
300 V
3000 V
300 mA
10 A
300 ohm
3 kohm
30 kohm
300 kohm
3000 kohm
30 megohm
320 ohm
(Fixed Range)
3.000
(Fixed Range)
3000
(Fixed Range)
Notes:
1. Use the RANGE CONTROL
switches (AUTO/MANUAL, UP and
DOWN) for ACV/DCV/kQ functions.
The 300 mA and 10 A current ranges
are not affected by the RANGE CON-
TROL switches as they are single
range functions. Always press UP or
DOWN to change ranges when the
AUTO/MANUAL switch is pressed in
("RC" appears in the display).
2. In some DC and AC voltage ranges
with leads unconnected to any cir- -
cuit, the display may show a phan-
tom reading. This is normal. The high
input sensitivity produces a "wander-
ing" effect. When the test leads are
connected to an actual circuit, a real
measurement will be displayed.
3. See the unit of measure on the
display to distinguish the range when
two ranges have the decimal point in
the same position. For example, on
300 mV range the unit display is
"mV" versus "V" on 300 V range.
13