Micronta 22-195A - OPERATION PREPARATION; Installing Batteries

PREPARING FOR OPERATION
All you need to do is install four 1.5V "C"
batteries. We recommend that you use
alkaline type batteries — such as our 23-551.
The batteries should be removed whenever
the unit is not going to be used for a few
weeks.
Installing Batteries
1. Be sure that POWER is OFF and the test
leads are disconnected.
2. Put your fingers on both cavities and open
the battery/fuse compartment cover on the
rear by pressing the cover catches in the
direction of the arrow.
3. Snap the batteries in place. Watch polarity!
4. Press the battery/fuse compartment cover
back on.
When the batteries become weak, "BATT"
will appear on the left side of the display.
Replace all of the batteries. NEVER LEAVE
WEAK OR DEAD BATTERIES IN YOU UNIT.
Even "leak-proof" types can leak damaging
chemicals.