Micronta 22-195A - RESISTANCE MEASUREMENT SPECIFICS; Range Stabilization and Display; Resistance Range Notes

4. For resistances of approximately
1 megohm and above, the display may take a
few seconds to stabilize. This is normal for
high resistance readings.
As with the voltage range, use the measuring
unit display to determine the range the meter
is in. "KQ" or "Q" distinguishes between
300 ohm and 300 kohm, “MQ” or "KQ" dis-
tinguishes between 30 megohm and 30
kohm.
3000 Range
Notes:
1.
Some
devices
could
be
damaged
by
the
current
applied
during
resistance
measure-
ments.
The
following
table
lists
the
voltage
and
current
available
in
each
range.
300 ohm
3 kohm
30 kohm
300 kohm
3000 kohm
30 megohm
A is the open circuit voltage at the jacks in
volts.
B
is
the
voltage
across
a
resistance
equal
to
a
full
scale
value.
C
is
the
current
through
a
short
circuit
at
the
input
jacks.
All values are typical.