Microscan MicroHAWK MV-20 - Page 99

Serial Commands
D
MicroHAWK MV-20 / MV-30 / MV-40 Smart Camera Guide D-5
JOBINFO [[-slot=]n] [-v]
Gets job summary or info about slot n.
JOBINFO with no arguments returns a list of all jobs on the device.
-v = Verbose n. This option shows the amount of space that would be freed if the job were
deleted. It also lists the total disk space and free disk space.
JOBLOAD {[-slot=]<n>|-mem} [-r]
Loads a job from slot n or from memory when used with the JOBDOWNLOAD command
via FTP.
-r = Start inspections.
JOBSAVE [-slot=]<n>
Saves current job to slot n.
MEMAVAIL [-cp]
Returns available memory for device or coprocessor.
MEMCONTIG [-cp]
Returns maximum memory block for device or coprocessor.
MEMFRAGS [-cp]
Returns memory fragments for device or coprocessor.
MEMINFO [-cp] [-v]
Returns memory summary “avail/contig/frags” for device or coprocessor. Verbose.
NETDRIVE [-type=]{RSH|FTP} [-host=n.n.n.n] [-user=user] [-password
=password]
Creates a network drive on the device.
OFFLINE
Stops all inspections.
ONLINE
Starts all inspections.