Microsemi SA.22c - Page 29

SA.22c Rubidium Oscillator
Designer Reference and User Guide Revision D 26
989680.00000000hz
Ctl Reg: 004C, Res temp off: BFC53F7D., Lamp temp off: BFF92B93.
FC: disabled, Srvc: high
Command h: The following example shows the response to the command h for the SA.22c help menu:
r>h
a: Set FC Mode
f: Adjust DDS Frequency (delta e-11)
i: Info (show program info)
j: Display 1pps Delta Reg
k: Set 1pps TIC
l: Set Service Pin Sense
o: Set ACMOS Output Frequency 'N'
p: Display Control Reg
q: Set Control Reg
t: Save Tuning Data
w: Display Health Data
x: Exit Run Mode
r>
Command w: The following example shows the response to the command w for the SA.22c health data
(wellness):
r>w
AData:
SCont: 6012
SerNum: 3B8
PwrHrs: 8A
PwrTicks: E291DB
LHHrs: 85
LHTicks: 16CCE28
RHHrs: 85
RHTicks: 165353C
dMP17: 4156AE53.
dMP5: 3D3C8652.
dHtrVolt: 41852146.
PLmp: 3F7E1248.
Appendix: Microsemi Serial Interface Protocol
097-16313-201 Designer Reference and User Guide Revision B 29
PRes: 3FC3EE0D.
dLVthermC: B8530000.
dRVthermC: B9384000.
dLVolt: 3FA0E4AC.
dMVoutC: C87BD20F.
dTempLo: 412C0000.
dTempHi: 42B50000.
dVoltLo: 416156C8.
dVoltHi: 4185C42A.
iFpgaCtl: 004C
dCurTemp: 42540000.
dLVoutC: 3DF9793A.
dRVoutC: 3DE6A30F.
dMV2demAvg: 3F259383.
Note: Values are in hex format.
Command a: The following example shows the response to the command a followed by an integer sets